eDPI calculator: DPI × in-game sensitivity

Multiply your mouse DPI by the sensitivity you use in one game.

800 eDPI

800 × 1 = 800

No download, no account: it runs in your browser, Chromebooks included.

Low, medium or high for your game: Valorant · Counter-Strike 2 · Fortnite · Apex Legends · Overwatch 2

  1. 2.54 cm1 inch of mouse travel
  2. 800counts the mouse sends
  3. 800eDPI
  4. 17.6°turn of the view in Team Fortress 2
At 800 DPI, one inch of mouse travel sends 800 counts. Your sensitivity multiplies them, and that product is eDPI. The game then turns the view by its own angle for each count. Team Fortress 2 uses 0.022°, published in Valve's game code, so 800 eDPI turns the view 17.6° per inch and a full turn takes 52 cm. A game with a different angle per count turns a different amount for the same eDPI.

What is eDPI?

eDPI (effective DPI) is your mouse DPI multiplied by your in-game sensitivity. It lets players compare sensitivity in the same game even when their DPI differs: 400 DPI at sensitivity 1 and 800 DPI at 0.5 both make 400 eDPI and turn the view the same distance for each inch of mouse movement. Change either input to see the product immediately. The starting inputs are an arithmetic example, not a recommendation.

Equal products can compare two settings using the same game’s sensitivity scale. The 2D aim drill uses your browser pointer, not this eDPI.

What eDPI cannot convert

Different games can use different sensitivity scales and fields of view. An equal eDPI does not establish equal physical movement or aiming feel across games. The conversion below covers only games whose developer publishes how far one mouse count turns the view. See the formula and its limits.

Mouse travel for a full turn

For games whose developer publishes how far one mouse count turns the view, your DPI and sensitivity above give the mouse travel for a full 360° turn.

– cm for a 360° turn

Try this turn distance in the 3D aim trainer

This matches hip-fire turning. Scoped and zoomed sensitivity, field of view and mouse acceleration are not covered.

Why only this game

We work this out only with the angle a game's own developer publishes for one mouse count. Valve publishes it for Team Fortress 2 in its Source SDK 2013 game code. For the games below we have not found that figure in a file or page the developer publishes and we can check, so we leave them out rather than guess.

Not available for Counter-Strike 2, Valorant, Overwatch 2, Apex Legends, Fortnite, Call of Duty, Rainbow Six Siege, The Finals, Marvel Rivals, Quake Champions, Deadlock: we have not found the numbers needed to convert in anything their developers publish that we can check.

For Counter-Strike 2, Valorant, Overwatch 2, Apex Legends and Fortnite, we last checked each developer's own pages and Wikipedia on October 12, 2026.

Ubisoft publishes how Rainbow Six Siege multiplies its sensitivity settings, but not how far one unit of input turns the view. Each published value and the developer page it comes from is listed on our Sources page.

Switching games? Match your turn by hand

We have not found these games' turn angles in anything their developers publish that we can check, so our converter leaves them out rather than guess. A ruler gets you the real answer in a few minutes, because what your arm has learned is how far the mouse moves for one full turn.

  1. Keep the mouse on the same DPI, and turn off mouse acceleration (how to turn it off) so a faster sweep does not change the distance.
  2. In your old game, face a sharp mark such as a door frame, in a practice range or an empty match.
  3. Lay a ruler beside the mouse and move it slowly to the right until the view has turned once and the mark is back under the crosshair. That distance is your turn distance (cm/360).
  4. In the new game, face a mark and move the mouse the same distance. If the view turns past the mark, lower the sensitivity; if it stops short, raise it. Repeat until one slow sweep turns the view exactly once.
  5. Check it three times. Slow, steady sweeps give the same answer each time.

Like any converter, this matches hip-fire turning. Scoped and aim-down-sights sensitivity are separate settings in each game: set them in the new game once hip fire feels right.

Now that you know your turn distance, check that your mouse pad is wide enough for it: mouse pad sizes.

Try a related test